- Compatible With: SM-G925A, SM-G925V, SM-G925P, SM-G925R4, SM-G925T, SM-G925F
-
For Samsung Galaxy S6 Edge SM-G925V/G925P/G925R4/G925T/G925W8/G925I/G925F/G925A Signal Cable Replacement - Grade S+
Notes:
If the signal cable for Galaxy S6 Edge faced with some signal problems for example:
1. The signal flex cable is broken or damaged in the process of repairing.
2. The signal is unstable or immediate hang, sometimes good, sometimes bad.
3. When you are surfing on the internet, you cannot receive continuous information.
4. The voice information is often interrupted or cannot be heard clearly while your earpiece is in good state.
When you are facing with one of these problems, you should replace a new signal cable. We ETS here provides this original signal cable replacement for Galaxy S6 Edge.
Features:
This Galaxy S6 Edge signal cable is brand new original replacement.
This signal flex cable is compatible with Samsung Galaxy S6 Edge all versions.
How to Install / Tips:
Please try to handle the repair or replacement work in a dry and dust free environment without direct sunlight.
Special tooling is required when disassembling and reassembling the Samsung Galaxy S6 Edge signal cable.
The installation of any new parts should be done by a qualified person. ETS is not responsible for any damage caused during installation.
Samsung Galaxy S6 Edge Teardown Tutorial Guide and Video:
1. Remove the battery door.
1.1. Heat up the Galaxy S6 Edge's back cover.(Notice: the adhesive on the battery door is extremely strong. Be Very Careful! Apply heat for no longer than 1 min.)
1.2. Insert poker cards into the edge to remove the adhesive and widen the gap.(You will also need a case opening tool.)
2. Remove the rear housing.
2.1. Take the SIM card tray out.
2.2. Undo the 13 screws in the rear housing.
2.3. Separate the rear housing from the LCD Assembly with the help of a suction cup tool and a case opening tool.
2.4. Remove the 3 case button flex ribbon cables. (Notice: the case buttons are all interchangeable.)
2.5. Peel off the wireless charging coil. (Notice: the wireless charging coil is not compatible with S6.)
3. Remove the motherboard.
3.1 Remove the front facing camera.
3.2. Pry up the 2 antennas from the main board.
3.3. Disconnect the Galaxy S6 LCD screen and digitizer, battery, ear speaker, and home button flex cable connectors. Turn over the motherboard and disconnect the charging port flex cable connector.
3.4 Remove the ear speaker assembly.(Notice: The ear speaker flex cable includes the ear speaker and proximity sensor, and it is folded in a special way. Pay attention to it for reassembly.)
3.5 Remove the mic from the top of the logic board. (Notice: The Galaxy S6's mic is non-removable while the Galaxy S6 edge's mic is not.)
3.6 Remove the rear facing camera.
4. Remove the charging port assembly.
4.1. Undo the 2 screws near the earphone jack by the charging port. These screws are smaller than those in the rear housing. Then gently pry up the charging port assembly. (Notice: These 2 screws are smaller than others. Don't mix up them up during reassembly.)
5. Remove the battery.
5.1. Gently pry up the battery with a spudger tool. (Notice: Adhesive is applied to the front housing down the two sides of the battery’s length. You need to insert the spudger or other tool through the adhesive gently.)
5.2. Notice: We recommend using a plastic spudger to prevent damage to the device.
Samsung Galaxy S6 Edge Disassembly Video:
-
Customer also bought