- Compatible With: iPad Mini 3
For Apple iPad Mini 3 Digitizer Touch Screen Replacement - Black - Grade R
Screen Size: 7.9 inches
Screen Type: LED-backlit IPS LCD capacitive touch screen, 16M colors
Protective Material: Oleophobic coating
Compatibility: Apple iPad Mini 3
? This iPad Mini 3 Touch Screen replacement includes the Digitizer with Front Glass already attached.
? This iPad Mini 3 Digitizer Touch Screen replacement is brand new but NOT original.
? The Apple iPad Mini 3 Touch Digitizer is available in black and white. This is the black one.
? This replacement screen is compatible with iPad Mini 3 only.
How to Install / Tips:
? Please choose the right part before placing an order.
? Special repairing tools are required for assembling or disassembling the Apple iPad Mini3 Digitizer Touch Screen.
? Handle the vulnerable and fragile flex cable ribbon carefully.
? Please try to handle the repair or replacement work in a dry and dust free environment without direct sunlight.
? The installation of any new part should be done by a qualified person. ETS is not responsible for any damage caused during installation.
Work Before Disassembly:
Step 1. Please cover the shattered iPad mini 3 screen with transparent adhesive tape, which will protect your fingers from the tiny glass during the repair work.
Step 2. Shut off your iPad mini 3 before disassembly. (It may cause short circuit while your power is on during the repair work)
Disassembly Tutorial Guide:
1.Use the hair drier/heat gun to heat the iPad mini 3 edge up for 5 minutes to melt the adhesive. (Starts from the front part; both the glass and the metal back plate will be heated up, so please be careful when touching them)
2.Use the suction cup to pry up the panel a little bit and then insert a plastic opening tool to separate the digitizer from the rest part. (Much strength can be used here because the glass are adhered to the frame tightly)
3.Use the suction cup and opening tool to slide across the edges and pry up the panel slowly and carefully.
5.Remove 7 screws in the metal bracket.
7.Remove the metal bracket and disconnect 4 flex cables connecting to the logic board. The digitizer, LCD screen and metal plate are now removed from the rear housing assembly. If you are trying to replace the broken iPad mini 3 digitizer, by here is what you all need to do.
8.Pry up the 2 antennas connecting to the logic board.
9.Remove 3 screws in the left bracket.
13.Disconnect 4 flex cables connecting to mother board and remove the front facing camera. (Notice: the front facing camera is fixed on the back housing by adhesive. The front facing camera flex cable is clipped in. Handle carefully and gently.)
Customer also bought
Mobile Accessories Recommended